Radio Shack 32-3001 - Manual (Page 5)

5
Note: You can set the control to
any other position (except
0 ).
However, to get an accurate pre-
set, all the volume controls must
set to the exact same position.
5. While you use the microphone,
insert a flat bladed screwdriver
into the slot above the corre-
sponding volume control and
adjust it until you obtain a reading
of
0 on the OUTPUT LEVEL VU
meters.
6. Temporarily set the MIC main vol-
ume control to 0 .
7. Repeat Steps 4 through 7 to con-
nect and adjust the preset levels
of all your other audio input
sources.
Notes:
• Do not connect the high-level out-
puts of an audio source to the low-
level
PHONO CERAMIC 2
(ceramic) jacks.
• Except for the PHONO ceramic
inputs, you can connect any high-
level audio source (tuner, cassette
tape deck, CD player, magnetic-
cartridge turntable, or VCR) to any
set of input jacks.
• Connect the ground wires (usually
black or green) from your mag-
netic cartridge turntable to the
GND screw terminal on the back of
the mixer.
PRE-ADJUSTING THE
MONITOR LEVELS
To listen in privacy or monitor the au-
dio source inputs so you can locate an
exact passage or section before mix-
ing it into the
MAIN OUTPUT , insert a
pair of stereo headphones (not sup-
plied) equipped with a
1 /
4
-inch plug
into the PHONES jack on the lower left
front corner of the mixer. Your local
Radio Shack store sells a wide selec-
tion of headphones.
1. Set the volume control of the input
sources to be monitored to their
minimum settings.
(illus)
(illus)
(illus)
32-3001.fm Page 5 Tuesday, August 10, 1999 8:02 AM