Runco WIDEVISION CX-OPAL47 - Manual (Page 58)

Operation
44 Crystal Series LCD Installation/Operation Manual
PRE
L
IMINAR
Y
Table 4-2 describes the effects of adjusting the primary color hues.
• CMS Saturation: This control adjusts the color saturation level – the amount of that
color in a video image. Lower settings produce less saturated colors; a setting of “0”
removes that color from the image entirely. If the saturation is too high, that color will be
overpowering and unrealistic.
• CMS Luminance: This control adjusts the intensity or luminance of a given color.
The default setting for all CMS controls is 50.
Blue Enable: Blue Enable removes all red and green color information from the image,
simulating a blue filter. You can use it instead of a blue filter when performing color and tint
adjustments.
Factory Reset: To reset all Crystal Series LCD settings to their factory defaults, select
Factory Reset from the ISF Calibration menu and press ENTER. To confirm the reset,
press
or to highlight Yes and press ENTER again. This command is not
undoable. Use it with caution!
Table 4-2. Effects of Primary Color Hue Adjustments
Primary Color Press to move the color... Press to move the color...
Red Closer to magenta Closer to yellow
Yellow Closer to red Closer to green
Green Closer to yellow Closer to cyan
Cyan Closer to green Closer to blue
Blue Closer to cyan Closer to magenta
Magenta Closer to blue Closer to red