Regency FireWizard - Manual (Page 8)

Page 8 FPI FireWizard TM Remote Control Manual - IPI
Displaying Temperature in Celsius or Fahrenheit
The default setting of the Remote is to display the temperature in Celsius.
However, the Remote can be changed to display temperature in Fahrenheit by the
following steps:
1. Ensure the Remote is switched off by using the On/Off button.
2. Press and hold the “-” button.
3. While the “-” button is held down, press and release the “+” button, this will
toggle the temperature display between °C and °F.
This setting is stored in memory hence the Remote will continue to display the
temperature in Fahrenheit even if the battery is replaced.
Flame Height Adjustment
There are seven levels of flame settings that can be selected manually using the “+” and
“-” button.
Pressing and releasing the “+” button once will increase the flame to a higher setting.
Continuously holding down the “+” button will increase the flame gradually until it has
reached the highest setting.
Conversely pressing and releasing the “-” button once will decrease the flame to a lower
setting.
Examples of the display on the LCD are as follows:
Flame Setting = 1 Flame Setting = 3 Flame Setting = 7