Renesas Emulation Pod M37641T2-RPD-E - Manual (Page 12)

( 10 / 68 )
Notes on Downloading Firmware:
• Before using this product for the first time, it is necessary to download the dedicated firmware
(control software for the emulation pod built into the PC4701). Please note that, to do this, it is
necessary to start up the PC4701 in maintenance mode. For firmware download procedures, see
"4.2 Downloading Firmware" (page 40). Once firmware has been downloaded, the product can be
used by simply turning on the power.
• Do not shut off the power while downloading firmware. If this happens, the product will not start
up properly. If power is shut off unexpectedly, redownload firmware.
• Except when a target status error occurs, if self-check is not completed successfully, there may be
trouble with the product. In such case, contact your local distributor. However, perform the self-
check in the below setup.
(1) Target system: Not connected
(2) Emulation pod internal switches: At their factory settings
IMPORTANT
Note on Malfunctions in the PC4701 System:
• If the emulator malfunctions because of interference like external noise, do the following to remedy
the trouble.
(1) Press the RESET button on the emulator front panel.
(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then
reactivate it.
Note for PC4700 System:
• PC4700H products whose serial number ends with a number or D, DE, G cannot be used with the
M37641T2-RPD-E.
Example: 5KE100, 5KE100D, 5KE11DE, 5KE100G
Do NOT use it with the M37641T2-RPD-E. The PC4700 needs upgrading.
Example: 5LE123B
You can use it with the M37641T2-RPD-E.
Note on Map Settings (MAP Command):
• Always set the SFR area and the internal RAM area to EXT.
When you debug an MCU with flash memory, however, set addresses 0470H through 0FFFH to
INT. (The internal RAM size of the on-board evaluation MCU is 1 KB.) Because the internal RAM
size of the evaluation MCU is smaller than the RAM size of MCUs with flash memory, allocate
emulation memory.
You can set the mapping by issuing the MAP command in the script window of the emulator
debugger.
Example (when using an MCU with flash memory in the memory expansion mode):
MAP 0000,046F,EXT (SFR area and internal RAM area)
MAP 0470,0FFF,INT (Internal RAM area extended by emulation memory)
MAP 1000,7FFF,EXT (External area)
MAP 8000,FFFF,INT (Internal ROM area)