Roland VR-700 - Manual (Page 19)

21
Getting Ready
fig.ConnectPA.eps
1. Make sure that both the VR-700 and the equipment you
intend to connect are switched off.
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
2. Use audio cables to connect the VR-700’s rear panel
OUTPUT connectors to your playback equipment
(amplified speakers, mixer, etc.).
* Audio cables are not included. If you want to purchase these items,
please contact the dealer where you purchased the VR-700.
1. Connect your headphones to the PHONES jack on the
VR-700’s rear panel.
* Use headphones that have a 1/4” stereo plug.
Connecting Playback Equipment
Mixer, etc.
Power amp/speaker
Powered speaker
Headphones
About the XLR connector OUTPUT connectors
The XLR connectors are wired as shown in the illustration.
Before you make connections, check the wiring of the
equipment you intend to connect.
fig.XLRJack.eps
About the 1/4” phone jack OUTPUT connectors
If you connect a cable only to the L/MONO jack of the phone
jacks, the sound of the left and right channels will be mixed
and output in monaural.
* The stereo signal will be output from the XLR connectors.
* We recommend that you use stereo output. If you use
monaural output, the quality and character of the sound may
be affected, but this does not indicate a malfunction.
1: GND 2: HOT
3: COLD
Connecting an Amp and Speakers
Connecting Headphones
VR-700_e.book 21 ページ ２００９年１１月１８日 水曜日 午前９時２４分