Ryobi P545 - Manual (Page 11)

11 - English
OPERATION
CAUTION:
Remove battery pack from unit. Fill oil tank with
Ryobi Bar and Chain Lubricant before starting
the chain saw. Failure to lubricate the chain will
cause damage to the bar and chain.
CHAIN OIL SYSTEM
See Figure 6.

Use Ryobi Bar and Chain Lubricant. It is formu-
lated to perform over a wide temperature range
with no dilution required.
NOTE: Do not use dirty, used or otherwise contam-
inated oils. Damage may occur to the bar or chain.
 Carefully pour the bar and chain oil into the tank.
 Check and fill the oil tank when battery is
recharged, or as needed.
 Depress the oil tank cap several times to pump
the oil to the chain before starting the saw.
 Depress the oil tank cap every 20-30 seconds
while cutting to keep the chain lubricated.
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three months or longer) be
sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
APPLICATIONS
You may use this product for the following purposes:

Limbing and pruning branches from trees
 Felling small trees up to 7 in. diameter
 Bucking the fallen tree into shorter lengths
This product will accept Ryobi One+ 18 V lithium-
ion battery packs and Ryobi One+ 18 V nickel-
cadmium battery packs.
For complete charging instructions, refer to the
Operator’s Manual for your Ryobi One+ battery
pack and charger models.
TO INSTALL / REMOVE BATTERY PACK
See Figure 5.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of
the look-out button when carrying or transporting
the tool.
To install:

Place the battery pack in your chain saw. Align
raised rib on battery pack with groove in chain
saw’s battery port.
 Make sure the latches on each side of the bat-
tery pack snap in place and that battery pack is
secured in chain saw before beginning operation.
To remove:
Locate latches on side of battery pack and depress
both sides to release the battery pack from the
chain saw.
CAUTION:
When placing battery pack in your chain saw,
be sure raised rib on battery pack aligns with
groove in chain saw’s battery port and latches
snap in place properly. Improper assembly of
battery pack can cause damage to internal
components.
Fig. 6
Fig. 5
BATTERY
PACK
LATCHES
BATTERY
PORT