Roland MICRO CUBE Guitar Amplifier User Manual
Page 8
8
Panel Descriptions
11. REC OUT/PHONES Jack
When Using REC OUT
Use mono 1/4” phone plugs when
connecting to this jack.
Use the VOLUME knob (
4
) to adjust the
volume of the signal output from REC OUT
to the appropriate level.
When Using PHONES
Connect headphones to this jack.
The sound is output in mono.
*
No sound is played through the unit's speaker while the
REC OUT/PHONES jack is in use.
12. AUX IN Jacks
You can connect a CD player or other kind of
device and have it play along with your guitar.
Offers two types of jacks for external input; a
1/4” phone jack and a mini jack.
However, the speaker and REC OUT/
PHONES output is monaural.
*
Determine the volume level by adjusting the volume control
of the connected device. The MICRO CUBE’s VOLUME
knob (
4
) do not affect the input from AUX IN jacks.
13. POWER Switch
Turns the power on and off.
*
This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required before
the unit will operate normally.
*
Always make sure to have the volume level turned down
before switching on power. Even with the volume all the
way down, you may still hear some sound when the
power is switched on, but this is normal, and does not
indicate a malfunction.
*
Depending on the knob settings, the volume at first may
be too high when the power is turned on. Always be sure
to turn down the volume before switching on the power.
Switching the Power On and Off
*
Once the connections have been completed, turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1.
Make sure that all volume controls on the MICRO
CUBE and connected devices are set to 0.
2.
Turn on all the devices connected to the
MICRO CUBE
’s INPUT and AUX IN jacks.
3.
Turn on the
MICRO CUBE
.
4.
Switch on any equipment connected to the
MICRO CUB
E’s REC OUT/PHONES jack.
5.
Adjust the volume levels for the devices.
6.
Before switching off the power, lower the
volume on each of the devices in your system
and then TURN OFF the devices in the reverse
order to which they were switched on.
14. AC Adaptor Jack
Connect the included AC adopter to this jack.
*
Use only the AC adaptor included with the MICRO CUBE.
15. Cord Hook
Hook the AC adaptor cord here (p. 9).
16. Security Slot (
)
http://www.kensington.com/
16
14
15
13
12
11
MICRO_CUBE_e.book 8 ページ ２００３年１０月２９日 水曜日 午後５時１５分