Rosen Entertainment Systems 410X - Manual (Page 27)

410X 27
TROUBLESHOOTING
“Tinny” sound.
Check the “Downmix” setting in the SETUP menus and
ensure that it is set to “Stereo,” not “LT/RT.”
Picture “rolls.”
Check that the TV Type setting is correct for the monitors
being used. (See “Changing the Video Output Mode”.) PAL
video often “rolls” on NTSC monitors.
With a widescreen 16:9 monitor, I have black bars on the
top and bottom of my screen.
Change the TV Display mode to “Wide.”
SPECIFICATIONS
Supply voltage: 12V DC Nominal, 11-16V operating voltage*
Temperature: 0 o to 50 o Celsius*
Current consumption: Less than 3.0A
Video:
Television System: NTSC/PAL
Aspect ratio: 4:3, 16:9
TV encoder resolution: 10-bit DA converter
Video Signal-to-noise ratio: 65dB
Discs played:
DVD video discs—
5“ (12 cm) single-sided, single and double-layer
3“ (8 cm) single-sided, single and double-layer
Compact discs (CD-DA, VIDEO-CD, CD-R)—
5“ (12 cm) disc
3“ (8 cm) disc
Audio output level: 700mV RMS
Audio signal output characteristics:
Frequency response: 20 Hz - 20 kHz (CD audio/44.1kHz sampling
rate)
S/N ratio: 90 dB (JIS)
Crosstalk: -75dB
Dynamic range: Above 85dB
Distortion: 0.02% (1 kHz)
Digital audio output: SPDIF optical output (IEC 958)
* Note: Use of the 410X beyond the safe operating ranges listed can
cause temporary or permanent damage to the unit, and such damage
may not covered by the manufacturer’s warranty.