Rosewill RSV-R26 - Manual (Page 3)

Server RSV-R26 User Manual
Step 2
Install the center slide to both sides of the chassis, then secure the center slides
with M4*6L screws.
The rackmount chassis
To pull it out of the cabinet
Back-end
Front-end
Center slide rail x 2
M4 x 6L Screws
Attention:
1.
Put the center slide right next to the chassis. Align the center slide holes to the
chassis ＇mounting holes and install all 3 screws for each slide.
2.
From all the way out of the cabinet, the rail has front and back sections. Please do
not mix that.
3.
Please leave a 10-20mm space gap between the front point of the slide and the
handle of the chassis.
Step 3
Attach the 4 “L＂ brackets on to the 2 outer slide rails. Please do not make it tight so
that it will be adjustable according to the size of the cabinet.
Back-end Front-end
To pull it out of the cabinet
M4 x 6 Screws and washers
Attention:
1. Please do not tighten it so that the brackets can slide and adjust to the width of the
cabinet.
2.
While adjusting, please align the positions of “L＂ brackets on both 2 slide rails.
3