Roland CUBE-15x - Manual (Page 7)

7
Connections
Refer to the figure shown below to connect the CUBE-15X to
other equipment.
Switching the Power On and Off
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Make sure that all volume controls on the CUBE-15X
and connected devices are set to 0.
2. Turn on all the devices connected to the CUBE-15X ’s
input jacks (INPUT jack and AUX IN jack).
3. Turn on the CUBE-15X.
4. Switch on any equipment connected to the CUBE-15X’s
RECORDING OUT/PHONES jack.
5. Adjust the volume levels for the devices.
6. Before switching off the power, lower the volume on each of
the devices in your system and then TURN OFF the devices
in the reverse order to which they were switched on.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally. For protection from sudden big sound,
always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on
and off, but this is normal, and does not indicate a malfunction.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to “Power Supply” (p. 5).
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
* Before making the connections, be sure that the volume setting
of the VOLUME knob for both amplifiers is set to “0.”
* When connection cables with resistors are used, the volume
level of equipment connected to the inputs may be low. If this
happens, use connection cables that do not contain resistors,
such as those from the Roland PCS series.
Electric Guitar
CD/MP3 player
Recorder
Main Specifications
CUBE-15X
● Rated Power Output
15 W
● Nominal Input Level
INPUT (CLEAN channel): -10 dBu/1 M Ω
AUX IN: -10 dBu
● Speakers
20 cm (8 inch)
● Controls
POWER Switch
SELECT Switch
POWER SQUEEZER Switch
<CLEAN Channel>
VOLUME Knob
<LEAD Channel>
TYPE Switch (OVERDRIVE, DISTORTION, METAL,
METAL STACK)
GAIN Knob
VOLUME Knob
<EQUALIZER>
BASS Knob
MIDDLE Knob
TREBLE Knob
● Indicators
CLEAN Channel
LEAD Channel
● Connectors
INPUT Jack
AUX IN Jack
RECORDING OUT/PHONES Jack
● Power Supply
AC 117 V, AC 230 V or AC 240 V
● Power Consumption
18 W
● Dimensions
335 (W) x 240 (D) x 335 (H) mm
13-3/16 (W) x 9-1/2 (D) x 13-3/16 (H) inches
● Weight
7.1 kg / 15 lbs 11 oz
● Accessories
Owner’s Manual
* 0 dBu = 0.775 Vrms
In the interest of product improvement, the
specifications and/or appearance of this unit are subject
to change without prior notice.
CUBE-15X_e.book 7 ページ ２００６年８月７日 月曜日 午後１２時０分