RCA HT35713BD - Manual (Page 10)

8
Using Your System Remote Control
(Continued)
+ and - Used with the MENU button to select or adjust a function.
ANTENNA Changes the antenna input between ANT A and ANT B.
CHAN (Channel) Up or Down Selects next higher or lower channel in the TVÕs channel memory.
CLEAR Removes menus or status displays from the screen.
DELAY/CH CTRL Press to switch channel control between main picture and PIP picture.
DISPLAY Shows the status displays on the screen. Press repeatedly to see detailed program
information, if available.
GUIDE•RDM Press to display previews of the channels in the channel list. It will show 12
channels at a time and sequence through all channels. Press the channel number of the channel
you want to watch or press
GUIDE•RDM again to remove the channel guide.
INPUT•SEEK Press to switch between inputs ( 90,91,92 ) and the TVÔs tuner.
MENU/PROGRAM Displays the main menu. Repeatedly press this button to highlight the menu
item you want to access. Then press + or – to activate that menu or change that
menu item.
MOVE Arrows ( ) Moves the inset picture when the PIP function is on the screen.
MUTE Reduces the receiverÕs sound to its minimum level.
Numbers ( 0 through 9 ) Select a channel up to 99 by pressing two numbers. To select a cable
channel over 99, press and hold 1 until 1-- appears on the screen. Then press the other
two numbers.
PIP Brings up the small picture-in-picture window. Press again to remove the PIP window.
POWER Press once to turn off the TV. Press twice to turn off all components.
PREV CH•DISC Switches between the last two channels selected. Select one channel and then
use the number buttons to select another. Press PREV CH•DISC to toggle between the
two channels.
RESET•REP Resets the picture controls to their original factory setup.
SKIP Displays a count down timer on the screen. While this timer is on the screen you can
change channels to see what else is on. When the timer reaches 0:00, the TV will automatically
switch back to the channel it was on when the
SKIP button was pressed. Press repeatedly to
increase the amount of time.
SWAP AUDIO Not used in these systems.
SWAP PIP Swaps the main picture with the currently selected PIP picture.
TV Turns on the TV and puts the remote in TV mode.
TV MENU Displays the main menu. Repeatedly press this button to highlight the menu item
you want to access. Then press + or – to activate that menu or change that menu item. Accesses
the TVÕs menu no matter what mode the remote is in.
VOL (Volume) Up or Down Raises and lowers sound from the audio/video receiver.
Buttons
TV Function
Press the TV button to turn on the TV and audio/video receiver and set the remote to operate
the TV.