Russound ST2S - Manual (Page 33)

ST2S TUNER PROGRAMMING
ST2 TUNER SETUP MENU
Press Select
button to select
Sirius Tuner
Sirius Setup Menu
Controller, Diagnostics, Factory Initialization
and System Info Procedures
MEM
NAME
Procedure
BANK
NAME
Procedure
Sirius
Setup
Menu FACTORY
INIT
Procedure
CONTROLLR
ID
Procedure
SYSTEM
INFO
Procedure
DIAGNOSTICS
Procedure
This
Procedure
returns the
ST2 Tuner
to its
Factory
settings
Please
Wait
Cycle Power
YES
SOURCE
NUM
Procedure
FACTORY
INIT
Procedure
UPDATE
FIRMW
Procedure
SYSTEM
INFO
Procedure
TUNER
SETUP
Menu
Chassis
Setup
Menu
This
Procedure
is for
Factory
use
ONLY
Are you
sure?
Yes or No
NO
All Contrlrs
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
Mode
Band
4. Press MODE/BAND to enter the FACTORY INIT
menu.
5. “Are you sure” appears on the tuner. Using the
Tune Up/Down buttons, view the “Yes” and “No”
selections.
6. Press MODE/BAND to select. A “No” selection
returns to the top of the Factory Init menu. A
“Yes” begins the initialization.
7. “Please wait” appears on the tuner during the
process and “Cycle Power” appears when com-
plete.
8. Cycle power on the ST2S tuner.
System Info (SIRIUS)
The System Info menu shows the SIRIUS module
manufacturing build properties.
1. Enter the Setup Menu by pressing and holding
the SELECT button.
2. TUNER SETUP appears. Press MEM Up/Down
until SYSTEM INFO appears on the tuner.
3. Press MODE/BAND.
4. Press MODE/BAND at “Build Time” to view.
5. Press MEM Up/Down to advance.
6. Press MODE/BAND at “Build Date” to view.
7. Press MEM Up/Down to advance.
8. Press MODE/BAND at “Version” to view.
9. Press SELECT to exit the System Info menu.
(END OF SIRIUS TUNER SETUP)
33