Roksan Audio MK III - Manual (Page 5)

Roksan Audio ltd Kandy Integrated Amplifier User Manual
CLASSIFICATION: General Use Version 3.0
All specifications are liable to change without notice. E&OE Page 5 of 8 ENGLISH
ANTENNA CONNECTIONS
FM Antenna:
Connect the adaptor & the ‘T’ FM Antenna supplied to the antenna socket (1)
on the back panel. (NOTE: A high quality indoor or out door FM aerial can
improove the performance of your Kandy Tuner)
AM Antenna:
Connect the AM Antenna supplied to the antenna sockets (2) on the back
panel. (NOTE: A high quality AM aerial can improve the performance of your
Kandy Tuner).
IMPORTANT NOTE: For optimum performance it is recommended to use high quality inter-connect cables such
as ROKSAN HDC-02A High Definition Analogue Cable and ROKSAN HDC-01D High Definition Coaxial Cable
for aerial extensions.
S S W W I I T T C C H H I I N N G G O O N N
The Mains power switch (1) is located on the front panel of the Tuner. When switched ON, your Kandy
Tuner FL Display will illuminate with the word ‘ROKSAN’ for a few seconds it will then revert to the
previously selected preset.
U U S S I I N N G G T T H H E E C C O O N N T T R R O O L L S S
BAND SELECTION
Press the Band Selection Button (2) on the front panel to toggle between FM and AM. Notice on the
display the frequency indication will change from MHz to kHz and the preset indicator will also change
from ‘F’ to ‘A’ for FM and AM respectively.
AUTO/MANUAL SCAN
Press the Auto-scan Button (8) on the front panel to toggle between scan tuning and manual tuning.
Notice on the display if ‘AUTO’ is lit. If so by simply turning the Tune/Select Knob (6) by approximately
a ¼ turn clockwise or anti-clockwise, the tuner will automatically scan up or down until a strong enough
signal is detected. It will then stop at that frequency and if it happens to be a desired radio station, you
can store it in one of the preset memories. Otherwise, just turn the knob a little again and the tuner will
search for the next strong signal and so on.
In manual mode (‘AUTO’ not illuminated) turning the Tune/Select Knob will advance up or down the
tuning frequency to allow you select your desired radio station.
PRESET SELECTION
Press the Tune/Select Knob (6) to toggle between tuning and preset selection. Notice when preset
selection is chosen the preset indicator and memory indicator ‘MEM’ flash. Simply turn the knob anti-
clockwise to go back and clockwise to go forward to your desired preset (For example the 5
th preset
location: 05F). Once on the desired preset, press the knob again to complete your selection.
PRESET PROGRAMMING
You can programme up to 99 presets to your favourite radio stations. Once you have selected a radio
station, press the Preset Button (4); the preset indicator and memory indicator ‘MEM’ start to flash.
Simply turn the Knob (6) until you get to the desired preset number that you wish to store this station in
(For example the 11
th preset location: 11F or 11A if storing an AM frequency) and press the Preset
Button again to store and complete your selection.
O P E R A T I O N K a n d y AM / FM Tuner
Page 5