RIDGID R5013 - Manual (Page 11)

11
OPERATION
RIGHT
Fig. 4
WRONG
Fig. 5
DRILL BIT
TO TIGHTEN
CHUCK JAWS
TO INSTALL BITS
See Figures 4 - 5

Unplug the drill.
 Insert the chuck key and twist counterclockwise.
 Open or close the chuck jaws to a point where the opening
is slightly larger than the bit size you intend to use. Also,
raise the front of the drill slightly to keep the bit from falling
out of the chuck jaws.
WARNING:
Make sure to insert the drill bit straight into the
chuck jaws. Do not insert the drill bit into the chuck
jaws at an angle then tighten, as sho
wn in figure 5.
This could cause the drill bit to be thrown from the
drill, resulting in possible serious personal injury or
damage to the chuck.
 Insert the drill bit.
 Tighten the chuck jaws securely on the drill bit, using the
chuck key provided.
 Remove the chuck key.
TO REMOVE BITS
See Figure 4.

Unplug the drill.
 Loosen the chuck jaws using the chuck key provided.
 Remove the drill bit.
 Remove the chuck key.
TO LOOSEN
CHUCK KEY
CHUCK
CHUCK KEY
STORAGE