Raymarine Ray215 - Manual (Page 41)

3-18 Operation with a Fist Microphone
PRESS & REL
DSC + D/L PRESS & REL
DSC
ROTATE
CH
PRESS & REL
DSC
PRESS & REL
DSC
PRESS & HOLD
DSC
MMSI digit digit position
Select desired digit Next digit position Select desired digit
Continue thru last digit position
Radio enters DSC mode
Radio replays all digits...
MMSI number accepted
PRESS & RELEASE
DSC
Process starts over
...through the 9th position
ROTATE
CH
Select desired digit
ROTATE
CH PRESS & RELEASE
DSC
Radio replays all digits through the 9th position
10. After you have selected the other ship's MMSI number, the radio
prompts you for the working channel you wish to communicate on.
The large character display shows the last used channel number and a
"W" appears in the small channel display. Using the Channel Select
(CH) knob on the front panel, select the desired working channel for
the Individual Call.
11. Press the DSC/PRI key once. The TX indicator on the LCD flashes,
indicating the RAY215 is ready to transmit.
12. Press the PTT key to send the digital "packet" of information. The
radio waits for an acknowledgment from the targeted ship or station.
13. If the target station acknowledges, a tone sounds and "ACK" illuminates
on the LCD. After 2 seconds, the RAY215 switches to the previously
selected working channel.
or
If the call is not acknowledged, exit the DSC mode by pressing the 16/
9 key.