RIDGID AQUAPRO TP-250 - Manual (Page 7)

TP-250 Utility Pump
Ridge Tool Company 5
Suggested Part Replacement Schedule
Replace motor every 5 years. See page 6 for RIDGID
cat. 90202.
SERVICE AND REPAIR
Service and repair work on this
pump must be performed by qualified repair personnel.
Pump should be taken to a RIDGID Independent
Authorized Service Center or returned to the factory.
All repairs made by RIDGID service facilities are war-
ranted against defects in material and workmanship.
When servicing this pump, only iden-
tical RIDGID replacement parts should be used.
Failure to follow these steps may create a risk of flood-
ing, property damage, fatal electrical shock, or other
serious injury.
!
WARNING
!
WARNING
If you have any questions regarding the service or
repair of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44036-2023
Tel: (800) 519-3456
E-Mail: [email protected]
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool
Company at (800) 519-3456 or http://www.ridgid.com
TROUBLESHOOTING CHART
Symptom
Pump will not start or
run
Pump starts but
delivers little or no flow
Possible Cause(s)
1. Blown fuse or breaker
2. Low line voltage
3. Worn motor
4. Impeller not rotating
5. GFCI
6. Thermal Protector open
1. Inlet screen clogged
2. Low line voltage
3. Restriction in discharge hose
4. Discharge lift too high
Corrective Action
1. If blown, replace with the proper sized fuse or reset the breaker.
2. If voltage is under 108 volts, check wiring size.
3. Replace motor or pump.
4. If impeller will not turn, disconnect pump from power source, remove
volute cover and remove blockage.
5. Test GFCI, replace if worn.
6. Motor locked up, replace motor (RIDGID Cat. 90202).
1. Clean debris from screen.
2. If voltage is under 108 volts, check wiring size.
3. Unwind garden hose, remove any kinks or restrictions in hose.
4. Water level to end of garden hose is 25 ft. or greater.