Russound BGD1 - Manual (Page 6)

6
Setup for IR Control
1. Connect Decoder to audio system. With the
audio system turned off, use an RCA patch cable
to connect from the Decoder’s outputs to a source
input on the audio system. Use an IR link cable or
mono patch cable with
1 ⁄
8
-inch (3.5 mm) TS connec-
tors to connect from the system’s IR output to the
Decoder’s IR input.
2. Select IR function. Set the source/function
selector switch on the Dock to IR for infrared con-
trol of the iPod.
3. Power Dock and Decoder. Plug the power
adapters into AC power receptacles and connect
their output leads to the device power jacks.
4. Dock iPod. Put the iPod in the Dock with the
appropriate iPod adapter.
5. Turn on audio system. Power up the audio
system and select the source input you’re using for
the iPod. As long as the iPod is playing, you should
hear it through the audio system.
6. Program audio system. Configure the audio
system for IR control of the iPod.
Firmware Update
From time to time Russound may offer updated
firmware for the BGD1 iBridge Dock. You can
download updated firmware from the Document
Center at www.russound.com.
1. Disconnect power. Unplug the power adapter
from the Dock.
2. Select program function. Set the source/
function selector switch on the Dock to PRGM.
3. Reconnect power. Plug the power adapter into
the Dock’s power jack.
4. Connect programming cable. Remove the
rubber plug from the OS update port on the Dock.
Connect an Advanced Programming Cable,
Russound part number 2500-521065, between the
OS update port and a serial port on a Windows-
based personal computer.
5. Run update program. Run the update soft-
ware on the computer to load the firmware into the
Dock.
6. Disconnect power. Unplug the power adapter
from the Dock.
7. Restore source selection. Return the
source/function selector switch on the Dock to the
previous source setting.
8. Reconnect power. Plug the power adapter into
the Dock’s power jack.
Installation