Roku SoundBridge Wi-Fi Music System - Manual (Page 49)

48
SECTION 10: ALARM CLOCK
Introduction
You can set your alarm to play any preset or to a variety of alarm tones. The SoundBridge Radio
alarm is designed to awaken you gradually, starting out softly and gradually ramping up in
volume. You can adjust the final volume level reached by the alarm. SoundBridge Radio has
two alarms, which can be set to go off at two different times during the day. Each is equipped
with a snooze alarm.
Setting the Alarm
To set your alarms or check your alarm settings, follow these steps:
Press the Alarm [ ] button on the top of the radio. You will see the dual alarm display as
illustrated below. This shows you whether the alarms are on or off, and at what time they will
sound.
 $/$50  2))   $0
$/$50  2))   $0  > @+ROGWRVHW
Continue to hold the Alarm [ ] button for a few seconds and you will be in the Alarm Set
mode. To switch from Alarm 1 to Alarm 2, you simply press the Scan Down [ ] arrow.
 $/$50  2))   $0  %X]]HU  9ROXPH
Use the navigation keys on the remote control, or the Source [ ] button on SoundBridge
Radio to move from option to option on the display. For example, to change the time, you will
press the
Source [ ] button two times from the Alarm 1 position.
Once you are positioned at an option you want to change, use the Scan Up [ ] and Scan
Down [ ] arrow buttons to change the settings.
When you are finished, press the Alarm [ ] button.
An alarm bell [ ] displays when the alarm is set. Thirty seconds before the alarm goes off, a
message displays telling you the alarm is about to sound, and you may press the Standby [ Ѷ]
button to turn off the alarm or press the Snooze button to defer it by 7 minutes.
Section 10: Alarm Clock