Raymarine RAY 210VHF - Manual (Page 32)

20
MEM (Memory): will appear on the LCD display to show the operator that the
displayed channel has been programmed into the Select Scan memory.
SCAN (All Scan): will appear on the LCD display when the radio is in the All
Scan mode.
WX (Weather): will appear on the LCD display when the radio is in the Weather
mode.
TX (Transmit): will appear on the LCD display when the microphone push-to-
talk switch has been pressed and the transmitter circuits are providing a signal to
the antenna.
1W (1 Watt, Low Power Setting): will appear on the LCD display when the
transmitter output power has been set to Low Power (1 Watt), or when a low
power channel has been selected using the channel selector knob.
F (Function): will appear on the LCD display when the [FUNC] key has been
pressed to operate a secondary key function. The secondary key functions are as
follows : SCAN, 1/25, DWX, MEM, and INTL.
LCD Bar Indicator: In the transmit mode, the 7 bars indicate transmitter
conditions. During low power transmit (1W), 3 bars will be displayed
continuously and a fourth bar will indicate modulation. During high power
transmit (25 W), 6 bars will be lit continuously and seventh bar will indicate
transmit modulation.
V (volt) : The DC supply voltage to the RAY210 will appear on the LCD
display for 5 seconds when the [VOLT] key is pressed.
CHANNEL #: The selected channel number will appear on the LCD display
when a communication, distress, or weather channel is selected by the operator.
Channel numbers will be displayed in two digits (01-88) for U.S A and INTL
channels as follows:
01 88
Weather channels WO to W9 are displayed in a single digit (0-9) on the LCD
display as follows:
0 9