Roland RG-1 - Manual (Page 76)

74
Changing Various Settings
When Composer MIDI Out is active, you can send
performance data recorded with the RG-1 to a connected
MIDI device or computer.
→ You can use the Memory Backup function to store these
settings to the RG-1 (p. 71).
1. Press the [Function] (Exit) button, getting its
indicator to light.
2. Press the [Song] (Select -) button or [ ] (Select
+) button to select “Composer MIDIOut” in the
MIDI screen.
fig.07-190d
3. Press the [ ] (Value -) button or [ ] (Value
+) button to switch the song’s MIDI Out setting
on or off.
4. Press the [Function] (Exit) button so the indicator
goes out.
Normally, you don’t need to install a driver in order to
connect the RG-1 to your computer. However, if some
problem occurs, or if the performance is poor, using the
Roland original driver may solve the problem.
Specify the USB driver you want to use, and then install the
driver.
1. Press the [Function] (Exit) button, getting its
indicator to light.
2. Press the [Song] (Select -) button or [ ] (Select
+) button to select “USB Driver” in the MIDI
screen.
fig.07-210d
3. Press the [ ] (Value -) button or [ ] (Value
+) button to select the USB driver.
4. Press the [Function] (Exit) button so the indicator
goes out.
• If you change this setting, turn on the power once again.
• This setting is remembered even when the power is
turned off.
• For details on downloading and installing the Roland
original driver, refer to the Roland website.
Roland website:
http://www.roland.com/
• For details on connecting your computer via the USB
connector, refer to “Connecting a Computer” (p. 82).
Sending Recorded Performance
Data to a MIDI Device
(Composer MIDI Out)
Value Description
On
The performance data recorded with the
RG-1 can be sent to the connected MIDI de-
vice or computer.
Off
The performance data recorded with the
RG-1 cannot be sent to the connected MIDI
device or computer.
Making the Settings for the USB
Driver
Indication Description
Generic
Choose this if you want to use the standard
USB driver that was included with your
computer.
Normally, you should use this mode.
Original
Choose this if you want to use a USB driver
downloaded from the Roland website.
RG-1_e.book 74 ページ ２００８年４月８日 火曜日 午後２時３６分