Regal Ware W15120 - Manual (Page 9)

-6-
11. Place a prepared mineral dispenser (see page 3) into the opening at the
top of the water bottle. Do not install cap onto water bottle.
The bottle must be left uncapped to allow water to enter it from the
AquaVié
™ unit.
12. Make sure that the dispensing valve is securely tightened onto the
water bottle.
13. The base of the AquaVié ™ chassis has raised edges to assist in
positioning the water bottle properly. Place the water bottle on the
base of the chassis.
NOTE: Do not remove the water bottle while the AquaVié ™ unit is running.
14. When the AquaVié ™ Healthy Water System cycle is complete (about 4 to
4 1 ⁄
2
hours), the AquaVié ™ unit will shut off automatically and the “start”
light will go out. The fan will continue to operate for several minutes.
Let the unit cool completely before removing the boiling
chamber from the chassis.
15. Unplug cord from wall outlet when not in use.
NOTE: Approximately 8 ounces (240 ml) of water will remain in the boiling
chamber at the end of the AquaVié
™ Healthy Water System cycle. This feature
reduces scale deposits in the boiling chamber.
CAUTION: To prevent personal injury, burn and/or scald injury, do
not remove the boiling chamber while the start button is illuminated
or at any time when the boiling chamber is hot. Always unplug the
AquaVié
™ unit from the wall outlet and allow the boiling chamber to
cool completely before removing it from the unit.
NOTE: The water bottle has been designed to hold one gallon (4 liters)
of water and to provide enough space so that the mineral dispenser does
not remain in contact with AquaVié
™ system water. Therefore, the water
bottle will not fill completely.
Once the AquaVié
™ system cycle is complete, the water bottle may be
placed in the refrigerator and used to dispense the distilled water. The
filter may be left in the water bottle or removed and stored until the next
time the AquaVié
™ system cycle is run. Secure the cap onto the water
bottle to avoid spilling. The cap must be opened slightly before dispensing
water. It is recommended that the water bottle NOT be placed in a freezer
as the handle may become brittle and crack.