Russound A-H1 - Manual (Page 2)

CONNECTION DIAGRAM FOR RUSSOUND ® MODEL A-H1. REFER TO THE INSTRUCTIONS ON BACK. DIAGRAMS ARE NOT TO SCALE.
B YPASS S TATUS
3 1 2 4
L INK
P OWER
K EYPAD O UTPUTS
A-H4P
P OWER
2,5A
+24V
N EWMARKET , NH U.S.A.
I NPUT
V+ B
V- BW
L+ G
L- GW
R+ O
R- OW
IR BL
ST BLW
V+
V-
L+
L-
R+
R-
IR
ST
V+
V-
L+
L-
R+
R-
IR
ST
4-Z ONE , 1-S OURCE
A UDIO S TRUCTURED W IRING H UB
S YSTEM O N IR
D ESIGNED I N USA M ADE I N K OREA
OUT IN
Pos (+)
Neg (–)
A-KP RC
ROOM
ON OFF
VOLUME
CD
TAPE
DSS
TUNER
8 7 6 5 4 3 2 1
110 punchdown connectors for Amplified Keypads
RJ45 Wall Plate (optional)
located near Hub
Audio Receiver
Audio Receiver
Source Component Alternate method: Connect 1 source directly
Standard method: Connect multiple sources
via Tape 2 or Zone 2 output of Receiver
RJ45 CAT-5
patch cable
When wiring use T568A RJ45 wire configuration
CAT-5
(behind wall)
To switched AC outlet
on Audio Receiver
A-H1
Emitter attaches to each source
component’s IR window
846C
A-KP RC A-KP2 A-VC
A-H4P
Brown V+
Brown/White V-
Green L+
Green/White L-
Orange R+
Orange/White R-
Blue IR
Blue/White
Status
CAT-5 Wiring Scheme for
110 punchdown connector
RJ-45 Connection Details
A-LRC1
Safety Instructions:
1. Read Instructions - All the safety and operating instructions should be read
before the appliance is operated.
2. Retain Instructions - The safety and operating instructions should be retained
for future reference.
3. Heed Warnings - All warnings on the appliance in the operating instructions
should be adhered to.
4. Follow Instructions - All operating and user instructions should be followed.
5. Water and Moisture - The appliance should not be used near water; for
example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet base-
ment, or near a swimming pool.
6. Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceil-
ing only as recommended by the manufacturer.
7. Ventilation - The appliance should be situated so that its location or position
does not interfere with its proper ventilation. For example, the appliance
should not be situated on a bed, sofa, rug, or similar surface that may block
the ventilation openings, or placed in a built-in installation, such as a book-
case or cabinet that may impede the flow of air through the ventilation open-
ings.
8. Heat - The appliance should be situated away from heat sources such as
radiators, heat registers, stoves, or other appliances (including amplifiers)
that produce heat.
9. Power Sources - The appliance should be connected to a power supply only
of the type described in the operating instructions or as marked on the appli-
ance.
10. Grounding or Polarization - Precaution should be taken so that the grounding
or polarization means of an appliance is not defeated.
11. Power Cord Protection - Power supply cords should be routed so that they
are not likely to be walked on or pinched by items placed upon or against
them, paying particular attention to cords at plugs, receptacles, and the point
where they exit from the appliance.
12. Object and Liquid Entry - Care should be taken so that objects do not fall and
liquids are not spilled into the enclosure through the openings.
13. Damage Requiring Service - The appliance should be serviced by qualified
service personnel when:
A. The power supply cord or the plug has been damaged; or
B. Objects have fallen, liquid has been spilled into the appliance; or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally; or
E. The appliance has been dropped or the enclosure is damaged.
14. Servicing - The user should not attempt to service the appliance beyond that
described in the operating instructions. All other servicing should be referred
to qualified service personnel.
Precautions:
1. Power – WARNING: BEFORE TURNING ON THE POWER FOR THE FIRST
TIME, READ THE FOLLOWING SECTION CAREFULLY.
All models are designed for use with either AC120V, 60Hz or AC240, 50Hz
voltages. The unit will autoswitch to either of these voltages.
2. Do Not Touch The A-H1 With Wet Hands – Do not handle the AH-1 or power
cord when your hands are wet or damp. If water or any other liquid enters
the A-H1 cabinet, take the A-H1 to a qualified service person for inspection.
3. Care – From time to time you should wipe off the front and side panels of the
cabinet with a soft cloth. Do not use rough material, thinners, alcohol or
other chemical solvents or cloths since this may damage the finish or
remove the panel lettering.
SAFETY INSTRUCTIONS