Ryobi SA1202 - Manual (Page 11)

Page 11
ADJUSTMENTS
INSTALLING BITS
See Figures 4 and 5.
■ Place the direction of rotation selector in center position.
This will lock the switch trigger in the off position.
See
Figure 10.
■ Open or close the chuck jaws to a point where the opening
is slightly larger than the bit size you intend to use. Also,
raise the front of your drill slightly to keep the bit from
falling out of the chuck jaws.
■ Insert your drill bit into the chuck the full length of the jaws.
See Figure 4.
■ Tighten the chuck jaws on the drill bit. To tighten, grasp
and hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of the arrow
marked GRIP to tighten the chuck jaws.
■ DO NOT use a wrench to tighten or loosen the chuck
jaws.
WARNING:
Do not insert drill bit into chuck jaws and tighten as
shown in figure 5. This could cause drill bit to be thrown
from drill resulting in possible serious personal injury
or damage to the chuck.
REMOVING BITS
See Figure 4.
■ Lock the switch trigger by placing the direction of
rotation selector in center position.
See Figure 10.
■ Loosen the chuck jaws from the drill bit .
■ To loosen: grasp and hold the collar of the chuck with
one hand, while rotating chuck body with your other
hand.
NOTE: Rotate chuck body in the direction of the arrow
marked UNLOCK to loosen chuck jaws.
■ Do not use a wrench to tighten or loosen the chuck
jaws.
■ Remove the drill bit from the chuck jaws.
NOTE: Rotate the chuck body in the direction of the arrow
marked GRIP to tighten the chuck jaws. DO NOT use a
wrench to tighten or loosen the chuck jaws.
24
20
5
WRONG
CHUCK JAWS
DRILL BIT
CHUCK COLLAR
CHUCK BODY
RIGHT
Fig. 4
24
20
5
Fig. 5