ROTEL RCD-951 - Manual (Page 9)

English
RANDOM Button 5 25
This instructs the CD player to play tracks from the entire disc in
random order. Once all of the selections have been played once,
the disc will stop playing, unless the REPEAT Button (see below)
has been engaged, in which case the random play will continue
until the STOP button is pressed. When the RANDOM button is en-
gaged, the word RANDOM appears in the Display.
REPEAT Button 9 23
This button allows you to repeat the current track or the entire
disc continuously until the feature is cancelled by disengaging the
REPEAT button or pressing STOP. The REPEAT button steps se-
quentially through the available options. Press the button once
and the RCD-951 will repeat just the current track, displaying the
indicators REPEAT 1 in the Display. Press the button a second time
and the RCD-951 will repeat the entire disc, displaying REPEAT
ALL in the Display. Press the button a third time to cancel the RE-
PEAT function.
As noted above, REPEAT can be used in conjunction with the
RANDOM play feature.
Note: The REPEAT function is automatically cancelled when the
disc drawer is opened.
SCAN Button 10 24
This feature automatically plays the first ten seconds of each
track on the disc (or the memorized program). To activate the fea-
ture, press the SCAN button. The word INTRO appears in the Dis-
play. To stop scanning and resume normal operation at the current
track, press the SCAN button again or press the PLAY button.
TIME Button 12 28
Normally, the RCD-951 displays the elapsed time of the currently
playing track. The TIME button allows you to step through two al-
ternative time displays. Pressing the button once displays the time
remaining in the current track, which counts down as the track
continues playing. Pressing the button a second time displays the
time remaining on the entire disc (or memorized program). Press-
ing the button a third time reverts to the standard elapsed time
display. When the TIME feature is activated, the word REMAIN
appears in the Display.
5
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Specifications
Total Harmonic Distortion + Noise 0.0045% @ 1kHz
Intermodulation Distortion 0.0045% @ 1kHz
Frequency Response (
±
0.5 dB) 20-20,000 Hz
Channel Balance
±
0.5 dB
Phase Linearity
±
0.5 degree
Channel Separation > 100 dB @ 1kHz
Signal to Noise Ratio > 105 dB
Dynamic Range > 100 dB
Digital to Analog Converters 18 Bit, precision DAC
Digital Filter 18 Bit, 8x oversampling
Speed Accuracy, Wow & Flutter Quartz Crystal Precision
Output Impedance 100 Ohms
Digital Output 0.5 Volt, Peak to Peak
Load Impedance 75 Ohms
Power Requirements 120 Volts, 60 Hz or
220-240 Volts, 50 Hz
Power Consumption 20 Watts
Dimensions (W, H, D) 440 x 72 x 316 mm
17
3/8 x 2 7/8 x 12 7/16 inches
Weight (net) 5.4 kg, 11.9 lb.
All specifications are accurate at the time of printing. Rotel reserves the right to make improve-
ments without notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.
HDCD is a registered trademark of Pacific Microsonics, Inc., Berkeley, CA, USA.