Radio Shack 33-3024 - Manual

OWNER’S MANUAL — Please read before using this equipment.
© 2000 Tandy Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by Tandy Corporation.
Unidirectional Dynamic Microphone
Your RadioShack Unidirectional Dynamic Mi-
crophone delivers acoustic clarity and accu-
racy. The pickup pattern controls feedback,
reduces pickup of undesired signals, and
provides increased sensitivity. Use your mi-
crophone for high-quality recording and
sound-reinforcement applications where you
want wide, smooth frequency response.
Its other features include:
13-Foot Cable — connects easily to a PA or
recording system with a
1 / 4 -inch jack.
Wire-Mesh Windscreen — cuts down on
wind noise and breath pops.
Built-In On/Off Switch — gives you conve-
nient microphone control.
Microphone Holder — swivels so you can
easily adjust the microphone’s position.
OPERATION
Note: To prevent feedback, make sure the
microphone's ON/OFF switch is set to OFF
before connecting it to a PA or recording sys-
tem.
1. Plug the microphone's 1 / 4 -inch (6.35-
mm) plug into the microphone jack on
your PA or recording system.
2. Turn on your PA or recording system.
3. Set ON/OFF to ON to turn on the micro-
phone. When you finish using the micro-
phone, set ON/OFF to OFF.
CARE
To enjoy your Unidirectional Dynamic Micro-
phone for a long time:
• Keep the microphone dry. If it gets wet,
wipe it dry immediately.
• Use and store the microphone only in
normal temperature environments.
• Handle the microphone gently and care-
fully. Do not drop it.
• Keep the microphone away from dust
and dirt.
Modifying or tampering with the micro-
phone’s internal components can cause a
malfunction and might invalidate its warranty.
If your microphone is not performing as it
should, take it to your local RadioShack store
for assistance.
USING THE MICROPHONE
HOLDER
To use the supplied microphone holder with
your microphone, screw it onto the top of a
microphone stand (not supplied), then slide
the microphone into the larger end of the
holder.
Mounting on a Stand
Microphone Holder
Screw mi-
crophone
holder onto
stand in a
clockwise
motion.
33-3024.fm Page 1 Tuesday, March 14, 2000 4:46 PM