Radio Shack Xmods 60-391 - Manual (Page 4)

 www.xmodsRC.com www.xmodsRC.com

Installing Batteries in the Chassis
 Make sure the power switch on the
bottom of the chassis is in the OFF
position.
 Remove the screw on the battery
compartment cover with the supplied
screwdriver.
 Carefully push either side of the battery
compartment cover to disengage the
latch, and then lift up the cover.
 Insert four AAA alkaline or rechargeable*
batteries in the compartments, matching
the polarity symbols (+ and –) marked
inside.
 Snap the cover back in place and replace
the screw from step 2.
* Pick up an optional battery charger
kit with rechargeable AAA batteries at
RadioShack.


Assembling the Car Antenna
 Remove the antenna screw on the right side
of the chassis.
 Thread the screw through the metal loop at
the base of the antenna.
 Thread the antenna screw back into its slot
and tighten.
Note: Be sure not to lose the antenna screw’s
washer.
Redistributing the Car’s Weight
You can shift the weight of the batteries to alter
your car’s center of gravity to optimize handling
in different driving conditions.
 Remove the two battery compartment
screws.
 Slide the battery compartment to the
desired position.
 Set the screws from step 1 in the holes and
tighten until snug.
