Roksan Audio Kandy MkIII - Manual (Page 4)

Roksan Audio ltd Kandy Integrated CD Player MkIII User Manual
CLASSIFICATION: General Use Version 2.00
All specifications are liable to change without notice. E&OE Page 4 of 11 ENGLISH
A A C C M M A A I I N N S S S S U U P P P P L L Y Y
Your Kandy CD Player is set to operate from a fixed supply voltage which is marked on a label next to the mains
input plug. Before connecting the mains lead please check that your mains supply corresponds to this label as
below:
230V Products ………………………………….Voltage Range: 220V – 240V
115V Products ………………………………….Voltage Range: 110V – 120V
100V Products ………………………………….Voltage Range: 90V – 110V
The mains lead supplied with this product has an IEC mains socket which plugs into the IEC connector on the
unit’s rear panel. The other end is normally attached to the appropriate mains plug for your country. In the UK
this is the standard UK13A plug.
This plug should ordinarily not be removed from the lead. If you do remove it, please dispose of it safely so that it
cannot be plugged into a mains socket whilst in a potentially dangerous condition. We suggest that you obtain
from your dealer a complete replacement lead.
Should you move to another area where either the mains voltage or the mains plugs are different from those as
supplied with your CD Player, please contact the appointed ROKSAN distributor for assistance.
Please observe correct mains polarity at all times.
The CD Player mains fuses are located on the rear panel next to the IEC mains connector. They must only be
replaced by the fuse of the type and rating as described on the fuse rating label on the rear panel of the unit.
This product requires connection to earth (ground). The earth wire (in the UK this is colour coded green/yellow)
of the mains cable supplied with your CD Player must be connected to a suitable earthing point established for
this purpose by your electricity supply company. If you are in any doubt, consult a qualified electrician.
If the equipment is likely to be unused for some time, unplug it from the mains supply.
G G E E N N E E R R A A L L C C A A U U T T I I O O N N S S
FCC WARNING
This equipment may generate or use Radio Frequency energy. The user may lose the right to operate this
equipment if unauthorised modifications are made.
INTERFERENCE
Properly installed, this unit should not cause harmful interference to radio communications, There is, however, no
guarantee that such interference will not occur in a specific installation. If interference arises (which you can
determine by switching the unit off and on) you could try to remedy matters by the following:
• Re-orient or re-locate the receiving antenna
• Increase the distance between the CD Player and receiver
• Connect the unit to a different mains circuit from that of the receiver
• Consult your ROKSAN appointed dealer or an experienced Radio/TV technician for help and advice
LOCATION
Your Kandy CD Player should be located in a well ventilated area and kept away from sources of heat, dust and
humidity and from direct sunlight.
The CD Player may be positioned either as a free standing unit or alongside another audio/video product.
Never place the CD Player on carpet or any surface likely to hinder normal ventilation.
Never allow liquids or other objects to fall into the unit.
This unit contains no user serviceable parts. Do Not remove any panels or attempt to service it yourself.
Unauthorised servicing will void the warranty.
C A U T I O N S K a n d y Integrated CD Player