RBH Sound CA-200 - Manual (Page 5)

3
Amplifier Controls and Setup
(continued)
9. High/Speaker Level Input: These binding post terminal connections are for the amplifier/
speaker level input from an amplifier or receiver.
IMPORTANT! Use either the Line Input or the High Level Input. DO NOT use them both
simultaneously.
10. High Level/Speaker Output: This is a 100 Hz high-passed output for your satellite/main
speakers. The crossover limits the low frequencies (below 100 Hz) from going to your satellite/
main speakers. This crossover is active only when using the High Level Input terminals.
Connect your main speakers (observing the proper polarity) to these terminals when using
the High Level Inputs.
11. Fuse Access: This is the power fuse access.
WARNING! In the event the fuse must be replaced, the replacement fuse must match
exactly the original fuse value. If the replacement fuse is not of the same value, damage
to the amplifier may result.
CAUTION! Before replacing the fuse, disconnect the power cord from the power receptacle.
CA-200 Subwoofer Amplifier Diagram