Rollei Flexline 140 - Manual (Page 43)

EN-42
3. If you select [Single] in the previous step, the
figure shown on the right hand side will appear.
„ Select the image that you want to print with
the e / f buttons.
„ Select the [Print Num.] (up to 99) with the c /
d buttons.
„ After selecting the desired image and printing
number, press the button to confirm.
4. Select [Exit] with the c / d buttons, and press
the button.
5. Select [Print] with the c / d buttons, and press
the button to start printing.
6. The printing starts and the figure shown on the
right hand side appears.
„ [COMPLETE] will be displayed temporarily,
reminding you that the printing procedure is
finished.
„ If an error is detected during the connection
(i.e. a printer hardware problem) between
camera and printer, [PRINT ERROR] will be
displayed.
„ If an error is detected during the
communication (i.e. wrong setting on the camera) between camera and printer,
[ERROR] will be displayed.
„ The image printing may fail if the power to the camera is cut off.
! !