Radio Shack ET-238 - Manual (Page 2)

ÐÐ
Set the ringer to sound or not.
You can make and receive calls
with the ringer off.
Switch to TONE or PULSE to match the type of service
you have. If you have pulse (rotary) service, you can
switch to TONE during a call to use tone services.
Press RESET to end a call without returning the
handset to the cradle.
Press FLASH in place of the switchook for
special services such as call waiting.
Press REDIAL to dial the last number dialed
(up to 31 tone or 32 pulse digits).
Press to disconnect a call.
Press for special services.
Use the memory index card
to record important phone
numbers.
Plug the handset cord into the jacks on
the handset and base.
Press MEMORY once to enter the
two-digit location (01-20) for the
number you want to store or to dial
the number in memory. See “Stor-
ing/Dialing Numbers in Memory.”
Press STORE once to enter the telephone
number you wish to store. See “Storing/Dial-
ing Numbers in Memory.”
Press PAUSE to enter a pause for systems
that require an access code (9, for example)
before you can dial an outside number.
STORING/DIALING NUMBERS IN MEMORY
To store a number in memory:
1. Lift the handset.
2. Press STORE.
3. Enter the telephone number you want to store.
Note: A pause entry counts as 1 digit.
4. Press MEMORY once.
5. Enter the 2-digit number (01 − 20) for the location
where you want to store the number.
6. Repeat Steps 3 − 5 to store additional numbers.
Return the handset to the cradle when you finish
storing numbers.
To dial a number in memory:
1. Lift the handset.
2. Press MEMORY.
3. Enter the two-digit location number for the number
you want to call.
USING THE PHONE MOUNTING THE PHONE
This symbol is intended to alert you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The phone company can charge you for the instal-
lation of the necessary jacks. The USOC number of the
jacks to be installed is RJ11C (RJ11W for a wall jack).
Modular
Telephone
Jack
Desk Mounting Wall Mounting
(With Wall Plate)
Short
Line
Cord
(Not
Supplied)
Wall Mounting
(Without Wall Plate)
Handset Holder
(Wall Mounting)
1. Pull out.
2. Rotate 180°.

1994 Tandy Corporation.
All Rights Reserved.
Radio Shack is a registered trademark used by Tandy Corporation.