Radio Shack PRO-79 - Manual (Page 26)

26
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper clip,
into the reset opening on the side of the scanner (as
shown). Then gently press the reset button inside the open-
ing. Information disappears from the display as you press
the reset button.
Note: If the scanner still does not work properly, you might need
to initialize the scanner (see “Initializing the Scanner”).
Initializing the Scanner
Important: This procedure clears all information you stored in
the scanner’s memory. Initialize the scanner only when you are
sure the scanner is not working properly.
1. Turn off the scanner, then turn it on again.
2. Hold down MON/CL .
3. While holding down MON/CL , insert a pointed object (such
as a straightened paper clip) into the reset opening on the
side of the scanner, then gently press the reset button inside
the opening. Information disappears from the display as you
press the reset button.
4. Release MON/CL . The display turns on.
Note: You must release the reset button before releasing MON/
CL ; otherwise the memory might not clear.
20-314.fm Page 26 Monday, December 13, 1999 12:55 PM