Rangemaster SxS Refrigeration U109200-03 - Manual (Page 15)

15 U109200-03
Maintenance and Cleaning
Cleaning the inside of your appliance
• Always disconnect the electricity supply before you
start cleaning.
• Empty the appliance of food and remove the shelves.
• The interior can be cleaned using warm water and
bicarbonate of soda, with a soft cloth. Make sure
that the interior is then dried carefully with a suitable
cloth.
 Do not use harsh abrasives, or aggressive
cleaners as these can damage the interior of
the appliance.
• Shelves and other accessories (plastic and glass
parts) can be cleaned in the sink using liquid dish
washing liquid and warm water. Make sure all soap is
rinsed off and all parts are dry before replacing them
inside the appliance.
• Always keep the door seals clean.
Removing the shelves/Salad/vegetable
crisper cover
• Lift the food shelf in an upward direction at the rear
(1) and pull it towards you (2). Then turn the shelf into
position (3). You must have the appliance door open
by at least 90°.
• To remove the crisper cover, remove the crisper
drawer first and then follow the above directions.
 Do not wash plastic parts in a dishwasher.
Clean the exterior of the appliance with a soft cloth and an
alcohol based cleaner. Do not use abrasive cleaners on the
exterior of the appliance.
The vents at the rear of the appliance should be cleaned
periodically using a soft bristled brush or the brush
attachment of a vacuum cleaner.
Once cleaning is completed, reconnect the electricity supply
and replace the food.
When not in use
If you are not using the appliance for an extended length of
time, it is recommended that you switch of the electrical
supply, empty any food out, clean the inside of the appliance
and leave the door ajar. This will save energy, and also
prevent a build up of stale odours inside.
Changing the plug (UK)
This appliance comes fitted with a 13amp plug fitted. Should
you need to replace the fuse, a 13amp ASTA approved
(BS 1362) must be used. Should the plug itself need to
be replaced, the wires in the mains lead are coloured in
accordance with the following code:
Green and yellow = Earth
Blue = Neutral
Brown = Live
Earth - Yellow/Green
Live - Brown
Neutral - Blue
Wiring of a standard 13 amp British three- pin plug
The wire coloured green and yellow must be connected to
terminal marked with the letter E, coloured green and yellow
or marked with the earth symbol:
The wire coloured blue must be connected to the terminal
marked with the letter N, or coloured blue.
The wire coloured brown must be connected to the terminal
marked with the letter L or coloured brown.
Upon completion, there must be no cut or stray wire present
and the cord clamp must be secure over the outer sheath.