Operation, Turning on the cb and receiving transmissions – Radio Shack TRC-446 User Manual

Page 12

Advertising
background image

12

OPERATION

Before you start using your CB, you
should know how to use it effectively
and courteously. “CB Operation Tips” on
Page 15 contains information that will
help you get more enjoyment from using
your CB.

TURNING ON THE CB AND
RECEIVING
TRANSMISSIONS

1. Turn

SQUELCH

fully counterclock-

wise.

2. Set

CH-9/NOR/CH-19

to

NOR

,

S/RF/

SWR/CAL

to

S/RF

(send and

receive), and

CB/WX/PA

to

CB

.

3. To turn on the CB, turn

OFF/VOLUME

clockwise until it clicks and you hear
a hissing sound. TX/RX lights, the
CB displays the last-tuned channel
number, and the SWR/RF/Signal
Meter lights.

4. Turn

SQUELCH

clockwise until the

hissing sound stops.

Note: If the CB picks up unwanted,
partial or very weak transmissions,
continue to turn

SQUELCH

clockwise

to decrease the CB's sensitivity to
these signals. Turn

SQUELCH

coun-

terclockwise if you want to listen to a
weak or distant station.

5. Adjust

OFF/VOLUME

to a comfort-

able listening level.

6. To manually tune channels, turn the

tuning control beneath the display to
select a channel. The selected
channel number appears, and the
SWR/RF/Signal Meter shows the
signal strength.

To quickly tune to Channel 9 or 19,
set

CH-9/NOR/CH-19

to

CH-9

or

CH-

19

.

9

or

19

flashes.

Important: Always give emergency
communications priority on Chan-
nels 9 and 19. Your CB provides for
fast selection of Channel 9 and 19
for that reason.

Notes:

• Selecting either Channel 9 or 19

overrides the manual channel
selection control.

• All channels, with the exception of

Channels 9 and 19, by agree-
ment, are available for general
communications. Channels 9 and
19 are reserved for motorist
assistance and for reporting
emergency situations, hazardous
road conditions, and the like.

7. If necessary, turn

RF GAIN

clockwise

to boost the strength of a signal.

8. If you hear low-level popping-type

noise, set

NB/OFF

to

NB

to turn on

the noise blanking circuit.

9. To improve communication quality,

set

ACE/OFF

to

ACE.

This enables

the ACE circuit.

10. To turn off the TRC-446, turn

OFF/

VOLUME

counterclockwise until you

hear it click.

21-1574.fm Page 12 Thursday, May 13, 1999 4:03 PM

Advertising