Radio Shack BEDSIDE 12-260 - Manual (Page 2)

Enable/Disable the Alarm
1. Slide ALARM to ON or SNOOZE to enable
the alarm.
É
appears.
2. The alarm sounds at the preset alarm time,
becoming progressively louder the longer it
sounds.
3. To snooze, press WEATHER/SNOOZE. The
alarm stops for 10 minutes. After 10
minutes, the alarm sounds again until you
slide ALARM to OFF to turn it off. ©2003. RadioShack Corporation. 12-260
All Rights Reserved. Printed in China
RadioShack and RadioShack.com are trademarks 08A03
used by RadioShack Corporation. AO0165AAA1
This product is warranted by RadioShack against manufacturing defects in material and workmanship under
normal use for ninety (90) days from the date of purchase from RadioShack company-owned stores and
authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO
EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE
WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack
SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY
WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE
OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY,
INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF
TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt
as proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided
by law: (a) correct the defect by product repair without charge for parts and labor; (b) replace the product with
one of the same or similar design; or (c) refund the purchase price. All replaced parts and products, and
products on which a refund is made, become the property of RadioShack. New or reconditioned parts and
products may be used in the performance of warranty service. Repaired or replaced parts and products are
warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the
product made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident,
misuse, improper or abnormal usage, failure to follow instructions, improper installation or maintenance,
alteration, lightning or other incidence of excess voltage or current; (b) any repairs other than those provided
by a RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic
damage; (e) transportation, shipping or insurance costs; or (f) costs of product removal, installation, set-up
service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
12/99
Limited 90-Day Warranty
Step Five
RF Signal Strength
The signal strength indicator (
Ê
) shows the level
of receiving signal. If the signal is lost and the
signal loss reminder is enabled, the radio emits a
short beep at 30 seconds. The radio then beeps
every 30 second seconds (at 1 minute, 1.5
minutes, and so on) for 5 minutes. It then sounds
every five minutes until you press any key, or
until a signal is received.
If you press any key to silence the reminder, the
reminder beeps stop. If a signal is detected for
more than 10 minutes and then lost again, the
reminder beeps regenerate.
Step Seven
Specifications
Frequency Coverage (MHz):
Channel 1 ...........................................................................................................................................................................162.400
Channel 2 .......................................................................................................................................................................... 162.425
Channel 3 .......................................................................................................................................................................... 162.450
Channel 4 .......................................................................................................................................................................... 162.475
Channel 5 .......................................................................................................................................................................... 162.500
Channel 6 .......................................................................................................................................................................... 162.525
Channel 7 .......................................................................................................................................................................... 162.550
Receiving Sensitivity (at 12 dB SINAD) ................................................................................................................................ 0.3µ V
Signal to Noise Ratio ............................................................................................................................................................ 40 dB
Audio Output Power:
Maximum ...................................................................................................................................................................... 250 mW
At 10% THD .................................................................................................................................................................. 200 mW
Channel Selectivity ................................................................................................................................................ ±25KHz, 40 dB
Power Supply ............................................................................................................................................ 6 V DC 300mA Adapter
DC 6V battery for backup
Antenna ................................................................................................................................................. Telescoping Rod Antenna
Dimensions (HWD) .................................................................................................................................... 35.1 x 117.5 x 140 mm
Weight (without battery) ........................................................................................................................................................ 250 g
FCC Declaration of Conformity
This device complies with Part 15 of the FCC Rules . Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
The FCC Wants You to Know
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules . These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your local RadioShack store or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your weather radio.
Changes or modifications not expressly approved by RadioShack may cause interference and void the user’s authority to
operate the equipment.
Product: Bedside Weather
Radio
Model: 12-260
Responsible Party: RadioShack
100 Throckmorton
Fort Worth, TX 76102
Phone: 817-415-3200
FCC Information Care
Keep the weather radio dry; if it gets wet, wipe it dry immediately. Use
and store the weather radio only in normal temperature environments.
Handle the weather radio carefully; do not drop it. Keep the weather
radio away from dust and dirt, and wipe it with a damp cloth occasionally
to keep it looking new.
If your weather radio is not performing as it should, take it to your local
RadioShack store for assistance. To locate your nearest RadioShack,
use the store locator feature on RadioShack's website
(www.radioshack.com), or call 1-800-The Shack (843-7422) and follow
the menu options. Modifying or tampering with the weather radio's
internal components can cause a malfunction and might invalidate its
warranty and void your FCC authorization to operate it.
You can set the weather radio to respond to an
NWS (NOAA) alert broadcast in two ways:
ON — When ALERT is set to ON and an
alert broadcast is received, an alert sounds
for five minutes. To stop the alert and listen
to the broadcast, press WEATHER/
SNOOZE. Press WEATHER/SNOOZE
again to turn off the weather broadcast.
OFF — When ALERT is set to OFF and an
alert broadcast is received, an alert sounds
for 10 seconds. The radio then automatically
switches to the weather broadcast for five
minutes. Press WEATHER/SNOOZE to
switch from the alert tone to the broadcast
before the 10 seconds, or to stop the
broadcast before it automatically stops.
ON OFF SNOOZE
ALARM ON OFF
ALERT
Step Six