Roland CUBE 20XL - Manual (Page 8)

6
Connections
Switching the Power On and Off
Once the connections have been completed, turn on power to your
various devices in the order specified. By turning on devices in the
wrong order, you risk causing malfunction and/or damage to speakers
and other devices.
1. Make sure that all [VOLUME] knobs on the CUBE-20XL and
all the connected devices are set to 0.
2. Turn on all the devices connected to the CUBE-20XL’s input
jacks (INPUT jack and AUX IN jack).
3. Turn on the CUBE-20XL.
* Always make sure to have the volume level turned
down before switching on power. Even with the
volume all the way down, you may still hear some
sound when the power is switched on, but this is
normal, and does not indicate a malfunction.
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after power up is required before the unit will operate
normally.
4. Adjust the volume levels for the devices.
5. Before switching off the power, lower the volume on each of
the devices in your system and then TURN OFF the devices in
the reverse order to which they were switched on.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power outlet.
Refer to Power Supply (p. 3).
Foot switches
Recorder
Headphones
Electric Guitar
CD Player
Digital Audio Player etc
EFX/
SOLO
EFX/
SOLO
SELECT SELECT SELECT
B A
Set the switches as shown bellow.
or or
FS-6 FS-5U
* To prevent malfunction and/or damage to speakers or other devices,
always turn down the volume, and turn off the power on all devices
before making any connections.
* Before making the connections, be sure that the volume setting of
the [VOLUME] knob for both amplifiers is set to 0.
* When connection cables with resistors are used, the volume level
of equipment connected to the AUX IN jack may be low. If this
happens, use connection cables that do not contain resistors.