Radio Shack TRC-442 - Manual (Page 6)

6
Cautions:
• If you use the TRC-442 in a vehi-
cle, mount it securely to avoid
damage to the CB or vehicle or in-
jury to anyone in the vehicle dur-
ing sudden starts or stops.
• Do not mount the CB where it
could damage or interfere with the
proper operation of any passive
restraint safety device (an air bag
or seat belt).
Follow these steps to mount the CB
using the supplied hardware.
1. Using the mounting bracket as a
template, mark the positions for
the screw holes on the mounting
surface.
2. In each marked location, drill a
hole slightly smaller than the sup-
plied mounting bolts.
Caution: Be careful not to drill
into objects behind the mounting
surface.
3. Attach the bracket to the mounting
surface with the supplied mount-
ing bolts, lockwashers, washers,
and nuts.
Note: If you cannot reach behind
the mounting surface to attach the
nuts on the bolts, use the supplied
screws, lockwashers, and wash-
ers to secure the bracket.
4. Attach the CB to the mounting
bracket using the supplied rubber
washers and mounting knobs.
Rubber Washer
21-1586.fm Page 6 Thursday, August 5, 1999 9:50 AM