Radio Shack ET-148 - Manual (Page 7)

7
1. Press in on the side of the bracket
nearest the DESK label and lift the
bracket. Rotate the bracket 180
°
and insert it into the WALL slots,
then push it upward to secure it.
2. Plug one end of the supplied short
modular cord into the TEL LINE jack
on the back of the phone and plug
the other end into a modular phone
line jack. Then align the base’s key-
hole slots with the wall plate studs
(or screws) and slide the base
downward to secure it.
3. Lift out the handset guide, rotate it
180°, then snap it back into place so
it holds the handset.
Note: The handset holder above the
handset cradle lets you place the
handset on the holder without dis-
connecting the call.
CONNECTING THE
HANDSET
Plug one end of the coiled cord into the
modular jack on the handset. Then con-
nect the other end to the jack on the side
of the telephone base.
Handset
Guide
Handset
Holder
43-637.fm Page 7 Friday, August 13, 1999 10:45 AM