Radio Shack 49-2514 User Manual
Page 2
Prepar
at
ion
2
%
100'%6+0)
"
#
"%
#/'4#
Follow these steps to connect either the RadioShack Cat.
No. 49-2515 or 49-2516 camera. Use the cable that comes
with the camera to make the connections.
1. Connect the mini-DIN plug at one end of the 59-foot
cable supplied with the camera to the
CAMERA IN
mini-
DIN jack on the rear of the monitor.
2. Connect the other end of the cable to the mini-DIN jack
at the end of the cable from the camera.
3. Plug the monitor’s AC power cord into a standard AC
outlet.
You can also connect an additional camera to the
V-IN/A-IN
jacks, as long as you do not use these jacks to connect a
VCR.
1. Using the camera’s supplied 6-inch adapter cable,
connect the camera’s Audio Out plug to the monitor’s
A-IN
jack and the camera’s Video Out plug to the
monitor’s
V-IN
jack.
2. Connect the camera’s supplied AC adapter to the 6-
inch adapter cable’s
DC IN
barrel jack.
3. Connect the DIN plug on the other end of the cable to
the camera’s 59-foot cable and connect the long cable
to the cable on the camera.
You can also use these jacks to connect other cameras
which have video/audio output jacks.
7
5+0)
"
#
"8
+&'1
"5
748'+..#0%'
"5
9+6%*$1:
You can also connect the monitor to the RadioShack Video
Surveillance Switchbox (Cat. No. 49-2517). This switchbox
has two camera inputs to automatically switch the view
between two areas. You cannot use the talk and alarm
functions of the monitor if connected to the switchbox. The
switchbox has its own intercom and alarm controls, which
you must use in this configuration.
±
"016'5"
±
"
• You cannot use the alarm
function or talk with the
person near the camera with
this connection.
• To view any signal connected
to the V-IN/A-IN jacks, you
must press VCR, so the
indicator lights. Press VCR,
so the indicator goes out to
switch back to the other
camera view.
±
"016'"
±
"
Since the switchbox is connected
to the V-IN/A-IN jacks, you must
press VCR, so the indicator lights
to view /listen to signals coming
through the switchbox.