RedMax BC2600DL - Manual (Page 13)

Operation
• The product is equipped with a
centrifugal clutch mechanism, so the
cutting attachment begins to rotate as
soon as the engine is started by putting
the throttle into the start position. When
starting the engine, place the product
onto the ground in a flat clear area and
hold it firmly in place so as to ensure
that neither the cutting part nor the
throttle come into contact with any
obstacle when the engine starts.
• Avoid pulling the rope to its end or returning
it by releasing the knob. Such actions can
cause starter failures.
6.When the engine has started, move the
choke lever gradually downward to open
the choke.
7.Allow the engine to warm up for a half
minute before starting operation.
1.When restarting the engine immediately
after stopping it, leave the choke open.
2.Overchoking can make the engine hard to
start due to excess fuel. When the engine
failed to start after several attempts, open
the choke and repeat pulling the rope, or
remove the spark plug and dry it.
■ STOPPING ENGINE
1. Release the throttle lever and run the
engine for a half minute.
2. Shift the ignition switch to the STOP
position.
NOTE
NOTE
WARNING
• Except for an emergency, avoid stopping
the engine while pulling the throttle lever.
■ ADJUSTING IDLING SPEED
1. When the engine tends stop frequently at
idling mode, turn the adjusting screw
clockwise.
2. When the cutting head keeps rotating after
releasing the trigger, turn the adjusting
screw counter-clockwise.
• Warm up the engine before adjusting the
idling speed.
■ LINE HEAD USAGE
1. Always wear eye protection such as
safety goggles. Never lean over the
rotating cutting head. Rocks or other
debris could be thrown into eyes and
face and cause serious personal injury.
2. Keep the debris guard attached in
place at all times when the unit is
operated.
TRIMMING GRASS AND WEEDS
• Always remember that the TIP of the line
does cutting. You will achieve better results
by not crowding the line into the cutting
area. Allow the unit to trim at its own pace.
1. Hold the unit so the head is off the ground
and is tilted about 20 degrees toward the
sweep direction.
WARNING
NOTE
NOTE
❲ 13 ❳