Remington BB18125A - Manual (Page 11)

11 www.remingtonpowertoolscom
EN
GLI
S
H
TROUBLESHOOTING
SAVE THESE INSTRUCTIONS
Note: For additional help, visit our technical service web site at www.remingtonpowertools.com.
WARNING:
Unplug blower/sweeper from power source before servicing. Severe
injury or death could occur from fi re, electrical shock, or rotating impeller.
OBSERVED FAULT POSSIBLE CAUSE REMEDY
Blower does not start when you slide
the switch to the “on” position. 1. Battery not installed properly.
2. Battery not charged
1. Verify proper installation of bat-
tery.
2. Insure battery is charged per re-
quirements.
Battery runs slowly. 1. Battery is nearly depleted. 1. Recharge battery completely.
Battery discharges quickly. 1. Battery not fully charged.
2. Battery worn and will not hold
a charge. 1. Recharge battery completely.
2. Replace battery.
Battery not charging. 1. Charger not plugged in.
2. Battery not fully inserted into
charger base.
3. Charger cord not properly connect-
ed to charger base.
4. Charger damaged.
1. Plug charger into 120V 60 Hz AC
source.
2. Insure battery is inserted
correctly in charger base.
3. Insure batter cord is fully in
inserted into charger base.
4. Replace charger.