RCA series SCT-520 - Manual (Page 6)

6
PREPARATION
READ THIS BEFORE OPERATING
• Choose a location for your cassette deck carefully. Avoid
placing it in direct sunlight or close to a source of heat.
Also avoid locations subject to vibrations and excessive
dust, heat, cold, or moisture.
• Do not open the cabinet as this might result in damage to
the circuitry or electrical shock. If a foreign object should
get into the set, contact your dealer.
• When removing the power plug from the wall outlet,
always pull directly on the plug, never yank the cord.
• Do not attempt to clean the unit with chemical solvents, as
this might damage the finish. Use a clean, dry cloth.
• Keep this manual in a safe place for future reference.
CONNECTIONS
Connect your cassette deck to your receiver or amplifier using
the supplied audio cables.
1. Using one of the audio cables, connect the cassette deck’s
L
and
R LINE OUT
jacks to the receiver or amplifier’s left
and right tape input jacks.
2. Using the other audio cable, connect the cassette deck’s
LINE IN
jacks to the receiver or amplifier’s tape output
jacks.
Note: If you are not sure which receiver/amplifier jacks to
use, refer to your receiver or amplifier’s owner’s manual.
3. Plug the AC power cord into an AC wall socket.
LINE OUT
Jacks
LINE IN
Jacks
To AC Outlet