RCA Scenium HD65W20 - Manual (Page 19)

Setup and Connections
Chapter 1 15
The Advanced Connection
TV, VCR, and DVD Player With Amplifier
DIGITAL
AUDIO OUT
ANTENNA A
IN
ANTENNA B
IN
SATELLITE
IN
PHONE
JACK
ACCESS CARD
VCR 1
ANT. IN
RF OUT
OUT
VIDEO L R
CH3
CH4
TV
SATELLITE
DISH ANTENNA
CABLE OR
OFF-AIR ANTENNA
DVD
OUT
VIDEO L R S-VIDEO
AMPLIFIER WITH
OPTICAL INPUT
DIGITAL
AUDIO IN
L
R
POWER
VIDEO
AUDIO
L R
INPUT1
INPUT2
INPUT3
S-VIDEO AUDIO
R
L
Y P B P R
AUDIO OUTPUTS
FIXED VARIABLE
L R L R
EXT SPEAKERS EXT
INT
L R
+ +
COMPONENT VIDEO INPUT
CABLE OR
ANY ALTERNATE
RF SIGNAL, SUCH AS
A DIGITAL OR ANALOG
TERRESTRIAL ANTENNA
• To watch the VCR in this
connection, press INPUT on
the remote control until the
correct video input appears
(in this example, VID3).
Note that because the digital
decoder is in the TV, not the
VCR, you cannot record
digital channels.
• To watch the DVD player in
this connection, press INPUT
on the remote control until
the correct video input
appears (in this example, S-
VID1 ).
Please Read Before Using the Digital Audio Out Jack
This TV’s optical digital output jack fully complies with the international standard governing this type of jack (IEC958), and is
designed for connection to a Dolby Digital (AC-3 or PCM) receiver or Dolby Digital (AC-3 or PCM) decoder. Older equipment,
some of which is not fully compliant with IEC958, may not be compatible with the Dolby Digital bitstream. Such a connection
using anything other than Dolby Digital AC-3 or PCM receiver or decoder could create a high noise level, causing damage to
headphones or speakers.
Some cable systems may
require a “conversion
box.” If so, consult your
cable company’s box
tuning instructions for
details.
After you have made your
connections, program the
TV to tune to the correct
video input channel to see
and hear audio and video
from the attached
component (VCR, DVD
player, etc.). Program your
TV as described in the
“System Options and
Preferences” section of
this book.