Operation – RIDGID R2611 User Manual

Page 10

Advertising
background image

10

OPERATION

WARNING:

Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.

WARNING:

Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.

WARNING:

Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.

APPLICATIONS

You may use this tool for the purposes listed below:

Sanding wood or wood product surfaces

Sanding steel surfaces

Removing rust from steel surfaces

ATTACHING THE FRONT HANDLE

See Figure 2.

Unplug the sander.

Place handle in the desired position.

Tighten the handle by inserting the hex key into the

handle hole, engaging the hex screw inside, and turning
clockwise.

Fig. 2

HEX KEY

HANDLE

SANDING DISC SELECTION

Selecting the correct size grit and type sanding disc is an
extremely important step in achieving a high quality sanded
finish. Aluminum oxide, silicon carbide, and other synthetic
abrasives are best for power sanding. Natural abrasives,
such as flint and garnet are too soft for economical use in
power sanding.
In general, coarse grit will remove the most material and finer
grit will produce the best finish in all sanding operations. The
condition of the surface to be sanded will determine which
grit will do the job. If the surface is rough, start with a coarse
grit and sand until the surface is uniform. Medium grit may
then be used to remove scratches left by the coarser grit and
finer grit used for finishing of the surface. Always continue
sanding with each grit until surface is uniform.

Advertising