RCA VS2000 - Manual (Page 16)

TECHNICAL SPECIFICATIONS 29 MENU OPERATION 28
7. TROUBLE SHOOTING
Problem
Does not display LED on the
front panel or the receiver has no power.
No pictures on the screen
No sound
Remote Control does not operate
Poor picture quality
Searching Signal
Unrecognized smartcard
Please insert your smartcard
Solution
- Connect the power cord to the power outlet
properly.
- Check if the receiver is in standby mode.
- Check if the video output port is firmly
connected to the Tv.
- Check if you have selected the correct
channel or video output on your TV.
- Connect the audio cords properly.
- Check the volume level of the TV.
- Press
“ MUTE ” key.
- Point remote control directly towards the
receiver.
- Check and replace batteries.
- Check the signal strength in the “ Antenna
Setup ” menu .
- If this is low, try adjusting the alignment of
your dish.
- Connect the antenna cable properly.
- Check the LNB. Please replace LNB if
necessary.
- Check the position of the dish. Please realign
dish if necessary.
- Check the signal strength in the “ Antenna
Setup ” menu.
- Check the smartcard.
- Insert the smartcard.
About the Receiver
On - Screen Error Messages
: You can select this to “Default” or “User”
When “Mode” is “User” , you can change each color value.
: If your receiver connected to TV by using “VIDEO” or “S-VIDEO”
Connector , these items will change the color setting of TV
screen.
: If your receiver connected to TV by using “Component cable
“(Y-Pb-Pr)” , these three items will change the color setting of TV
screen.
Mode
Brightness
Contrast
Saturation
Sharpness
M_B_Y
M_G_U
M_R_V