Rockford Fosgate PWR-54/58 - Manual (Page 7)

I
N S TA L L I N G T H E
P
U N C H
P
O W E R
M
I D R A N G E
S
P E A K E R S
Since the PWR-34 and PWR-38 are most often used for direct
replacement of stock speakers, some of the following instructions
may not apply.
1. Determine where the speakers will be mounted. Ensure a flat area
large enough for the speaker to mount evenly. Determine that the
mounting location is deep enough for the speaker to fit; if
mounting in a door, operate all functions (windows, locks, etc.)
through their entire operating range to ensure there is no obstruc-
tion.
2. Refer to the chart below to determine the proper diameter hole to
cut for your speaker model.
MODEL DIAMETER
PWR-34/38 2-31/32" (75.4mm)
PWR-44/48 4" (101.6mm)
PWR-54/58 4-15/16" (133.35mm)
PWR-64/68 5-27/32" (148.4mm)
3. Using the plastic mounting ring as a template, mark the locations
for the mounting screws. Drill the holes with a 1/8" bit.
4. Slip the screw clips over the holes that were just drilled with the
flat side on the outer face.
5. Feed the speaker wires through the cutout and the plastic
mounting ring (from the flat side) and connect to the speaker
terminals. Be sure to observe proper polarity when connecting
the wires. The speaker's positive terminal is indicated with a dot.
On the 4
Ω
speaker the dot is violet and on the 8
Ω
it is red.
6. Fit the ring and speaker to the cutout. Mount them using the
enclosed screws. Fit the grille over the ring and press gently but
firmly into place.
4