Royal Sovereign ES-1300C - Manual (Page 6)

ES-1300C
6
2. Setting the correct temperature according to thickness
of film.
1) When using 3~4mil pouches, please refer to picture 4 .
Temperature Control settings.
2) When Photo laminating, Temperature Control Switch
should be in the "=" position, and wait 3~5 minutes before
laminating.
3) Do not attempt to laminate items that exceed total
recommended material thickness. (It may cause poor
quality lamination or damage of the laminator.)
1) When using 5mil pouches, make sure switch is in the "="
position shown in picture 5.
2) When Photo laminating, Power &Temperature Control
Switch should be in position "=" .
3) When changing Power &Temperature Control Switch from
position "=" to position "-" , wait 3~5minutes. (Poor
quarlitylamination will occur if wait time is not allowed.)
Picture 4
Picture 5
NOTE: Your finished laminated item will be hot, and will easily bend. To
keep your laminated item flat, place on flat surface and allow to cool or
lay item on the cooling guides.