Rockford Fosgate Power T2500-1bd - Manual (Page 8)

8
Power
Connection
8. Connect from source signal by plugging the RCA cables into the input jacks at the amplifier.
CAUTION
: Always ensure power is off or disconnected at the amplifier before
connecting RCA cables. Failure to do so may cause injury, damage to the
amplifier and/or connected components.
9. Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker terminal and tighten
the set screw to secure into place. Be sure to maintain proper speaker polarity. DO NOT chassis
ground any of the speaker leads as unstable operation may result.
10. Perform a final check of the completed system wiring to ensure that all connections are accurate.
Check all power and ground connections for frayed wires and loose connections which could cause
problems. Install inline fuse near battery connection.
NOTE:
Follow the diagrams for proper signal polarity.
CAUTION:
These amplifiers are not recommended for impedance loads below 1 or
2 per bridged (strapped) amplifier pairs.
Single Amplifier Wiring
I
NSTALLATION