Roberts Radio CR9935 - Manual (Page 17)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Operating your radio using RDS (Radio data system)
1. Switch on your radio and select the FM waveband.
2. Tune into a station, the display will indicate frequency for two
seconds and then change to show the station name. The
symbol will appear in the display
3. If the station does not carry RDS information only the station
frequency will be shown.
Note: the indicator will flash if the signal is too weak for RDS
operation.
Display Modes
After tuning to an RDS station, the display briefly indicates the
stations frequency and then the station name, after a few seconds
the display will revert to showing clock time.
1. To display the stations frequency press the Display button the
display briefly indicates the frequency followed by the station name.
If the station is not transmitting an RDS signal or the signal is too weak,
station frequency will be displayed instead of station name.
2. To return to time display press the Display button.
16
1
2
1
2