Radio Shack TD-1500 - Manual (Page 8)

8
USING THE SYSTEM
ACTIVATING THE REMOTE CONTROL
You must train the system to respond to the supplied remote
control. To activate the remote control, immediately after ap-
plying power, press DISARM on the remote. The system
beeps twice.
If the system loses power, the system stops responding to
the remote. To reactivate it, simply press DISARM on the re-
mote after power is restored.
Your system can learn two remote codes if you want to add a
second remote control (RadioShack Cat. No. 49-845). To ac-
tivate a second remote control code, be sure the system is
disarmed, then hold down ARM for 10 seconds. The status
indicator flashes. Press DISARM on the new remote to acti-
vate it. The status indicator stops flashing.
ARMING AND DISARMING THE
STARTER
To disable your starter, press ARM on the remote control. The
indicator flashes rapidly. If you try to start your vehicle, the
engine does not crank.
To enable the starter, press DISARM on the remote control.
The indicator turns off. The vehicle now starts as usual.
49-851.fm Page 8 Thursday, August 19, 1999 10:56 AM