RedMax HBZ2600 - Manual (Page 13)

 13 
Storage
BEFORE STORING THE BLOWER:
1. Drain a fuel tank and push the primer bulb
until it becomes empty of fuel.
2. Remove the spark plug and drop a
spoonful of 2-cycle oil into the cylider.
Crank the engine several time and install
the spark plug.
Maintenance
■ AIR INLET SCREEN
• Blowing air is taken in from the air inlet
screen. When air flow has dropped down
during operation, stop the engine and
inspect the air inlet screen for blocking by
obstacles.
• Note that failure to remove any such
obstacles may result in the engine
becoming overheated and damaged.
• Never use the blower without the
screen at the air intake of the blower.
Before each use, check that, the
screw(1) is securely tightened and is
free from any damage.
WARNING
IMPORTANT
■ PROCEDURES TO BE PERFORMED
AFTER EVERY 100 HOURS OF USE
• Remove the muffler, insert a screwdriver
into the vent, and wipe away any carbon
buildup. Wipe away any carbon buildup on
the muffler exhaust vent and cylinder
exhaust port at the same time.
• Tighten all screws, bolts, and fittings.